Metal panels fight the constant humidity and thunderstorm cycles here better than shingles. We use 26-gauge Galvalume with a 40-year paint warranty on most homes in West End and Old Town. The big failure point is rust at the screw lines when cheap crews skip butyl tape or use the wrong fasteners. We always check for that before we start.
Hurricane season brings wind-driven rain that finds every gap in a metal roof. Beaumont roofs see 50-plus mph gusts every few years so we install clips rated for 110 mph uplift on every seam. Jefferson County requires a permit and wind-load paperwork on anything over 400 square feet. Skip the permit and you risk a failed inspection after the next big storm.
Cheap crews often lay metal straight over two layers of old shingles. That traps moisture and rots the deck in under five years in our climate. We pull everything down to the rafters, add ice-and-water shield at the eaves, and use a synthetic underlayment rated for 180 days exposure. That step alone stops most callbacks.
We work around Lamar University and near the Botanical Gardens without blocking traffic. Panels arrive pre-cut so install noise stays low. If you need a commercial job on a shop in South Park we can do that too with 24-gauge material and longer purlins.
Metal Roofing Services We Offer
✓Standing Seam Metal Roof Installation
Full tear-off and new 24-gauge standing seam panels installed in three to five days on homes in Downtown Beaumont.
✓Emergency Metal Roof Repair Beaumont
Same-day leak fixes on damaged panels or seams after storms, available 24/7 from our Phoenix Dr shop.
✓Metal Roof Replacement Over Shingles
Remove old shingles and install new metal panels on one-story homes in West End within four days.
✓Commercial Metal Roofing Beaumont
Screw-down or standing seam systems on small commercial buildings near Spindletop Museum with 26-gauge material.
✓Metal Roof Leak Inspection
Walk the roof and check seams, flashings, and fasteners on Beaumont homes for $150.
Metal Roofing Cost in Beaumont, TX
| Service | Typical Range | What Affects It |
|---|---|---|
| Metal roof leak repair | $450–$950 | Depends on how many panels and seams need work plus access height. |
| Standing seam metal roof install | $11–$15 per sq ft | Higher price for 24-gauge material and complex roof shapes. |
| Screw down metal roof replacement | $9–$12 per sq ft | Lower cost when deck is solid and pitch is simple. |
| Commercial metal roofing | $10–$14 per sq ft | Larger jobs drop per foot but need longer purlins and heavier gauge. |
| Free metal roofing estimate | Free | We come out same day or next day and give a written number on site. |
Ranges are typical for Beaumont, TX and confirmed with an exact written quote before any work starts.
How it works
- 1
Site Visit and Deck Check
We climb the roof, measure pitch, note any rotted boards, and take photos in 30 to 45 minutes.
- 2
Material Order and Permit
We order Galvalume panels and pull the Jefferson County permit. Lead time is usually two to four days.
- 3
Tear Off and Underlayment
Remove old roofing, replace bad decking, and roll out synthetic underlayment plus ice shield at eaves.
- 4
Panel Install and Trim
Screw or seam the panels, install ridge cap, drip edge, and pipe boots. Final walkthrough same day.
Pricing
Most metal roofing jobs in Beaumont run $9 to $14 per square foot after we see the deck condition and access.